Avdel 07900 Manuel d'instructions

Instruction ManualOriginal InstructionThreaded Insert Power Tool74200

10Servicing the ToolIMPORTANTThe employer is responsible for ensuring that tool maintenance instructions are given to the appropriate personnel.The op

Service KitServicing the Tool11For all servicing we recommend the use of the service kit (part number 74200-99990) supplied in its own plastic case.07

12MaintenanceEvery 500,000 cycles the tool should be completely dismantled and components replaced where worn, damaged or whenrecommended. All ‘O’ rin

Differential ValveHead AssemblyRear CasingDistributorHydraulic Piston & Air Motor Assembly (74200-12610)Maintenance13• Wrap adhesive tape around h

14General Assembly of Base Tool 74200-1200083318281640616263646566676869707172737475767778791333491252622249290909944454647212019181774243605940899588

15Parts List for 74200-1200001020304050607080910111213141516171819202122232425262728293031323334353637383974200-1200174200-1200274200-1200374200-12004

16Oil DetailsHyspin®VG 32 Oil Safety DataPriming ProcedurePrimingPriming is ALWAYS necessary after the tool has been dismantled and prior to operating

17Fault DiagnosisPneumatic motor Air leak from motor Check for worn seals. Replace 13runs slowly Low air pressure Increase 7Air way blockage Clear res

18Fault DiagnosisTool does not Screw adaptor nut loose Tightenspin on No air supply Connect 7Insufficient gap between locknut 45 and Adjust to 1.5 mm

19Declaration of ConformityWe, Avdel UK Limited, Watchmead Industrial Estate, Welwyn Garden City, Herts, AL7 1LYdeclare under our sole responsibility

Since 1936 2010 Since 1922www.avdel-global.comwww.infastech.com TAUSTRALIAInfastec (Australia) Pty Ltd. 891 Wellington RoadRowvilleVictoria 3178Te

3ContentsSafety Rules 4Tool Specifications 5Intent of Use 6Tool Dimensions 6Putting into ServiceAir Supply 7Stroke Adjustment 7Operating Procedure 7Nos

4Safety Rules1 Do not use outside the design intent.2 Do not use equipment with this tool/machine other than that recommended and supplied by Avdel UK

Tool SpecificationSpecifications5Air Pressure Minimum - Maximum 5-7 bar (75-100 lbf/in2)Free Air Volume Required @ 5 bar/75 lbf/in28 litres (.28 ft3)S

6Intent of UseThe hydro-pneumatic 74200 tool is designed to place Avdel®threaded inserts at high speed making it ideal for batch or flow-line assembly

Air SupplyStroke AdjustmentOperating ProcedurePutting into Service7All tools are operated with compressed air at an optimum pressure of 5.5 bar. We re

8Fitting InstructionsServicing InstructionsNose AssembliesIt is essential that the correct nose assembly is fitted prior to operating the tool. By know

9Nose AssembliesNose tips vary in shape according to the insert type. Each nose assembly represents a unique assembly of components which can beordere